CIBAKHÁZA
Area of the factory in Cibakháza: 39000 m2. Parallel with the parts of formerly produced agricultural harvesters, we started producing steel pedestals. The technical background of our Szekszárd branch can be defined as follows:
Cold working:
Cutting and machining sheet with a thickness up to 10 mm, with general cutting machines, presses and benders, using general and specific tools. Cutting sheets thicker than 10 mm by cutting torch. Steel bar and profile cutting with cutting-off saw.
Welding::
Usually arc-welding electrode, manual CO2 or CO2 + AC shielded arc welding are applied. The same good experience we have with fine sheets of about 1 mm thickness as well as with large thicknesses.
Machining::
Other equipment of the branch: general turns and millers.
Surface treatment, coating:
Mechanical removal of oxides and cinders; sand blasting cleaners are at disposal. Degreasing procedure is well-organized; dispersive painting technology on a lightweight conveyor line enabled to apply chemical surface treatment and 2-layer solvent ink. Curing after painting is done in a convective oven; at present it is out of operation due to modernization.
Assembly:
By using conventional hand machines; practice of piece production an small series, non-automated.
|
